Видео

Thank you for your video

Easy to follow and informative. Thanks for sharing!

All good except for Dirt VS Concrete. Concrete holds water and will cause the post to rot faster at the bottom. Dirt however, will be better if done this way. Make mud in the hole around the post, treat it like you would the concrete and level it to the ground level. (just below the grass) Water dissipate faster keeping the post rotting fast and (most important) the post is much easier to replace when needed. As a Florida home owner I can tell you this; to replace a concrete post hole WILL break 1 of 2 things; Your back or your wallet. :-)

2 80's....damn son. Are you for real?

this needs to be at the top search

Basically did everything wrong...

I’m trying this.

How much transmission oil does a 2015 scion tc take? I hope your answer is very helpful.

How to di you open the gate from the outside??

He left out, and wait for it to crack!

Another idiot video. Another waste of time. Quit rushing through the connection parts. Push the camera closer to see the wires connecting. Pitiful instruction. Please quit.

You can use vegetables oil so concrete doesn't stick to the forms..also it's a good idea to connect the slabs with mesh just in case tge ground moves the will move together..

Lol. A 2 minute video got me this far. No more drip, no more hot. 😂

Another amateur instructing something he know nothing about.

My god thats my fantasy dock build.

Gasket can’t figure them where to put in order

NO.

I understand that this is just a small pad but I think I will go to the added expense (around $2) of some base and some rewire.

So if mine lights up off and on, this is the problem ?

And always a MEXICAN master finisher on the fresno is required to get a perfecto Job done ✅…

bookmark

My girlfriend asked if you are scared of the sun

I’m an independent woman and your video gave me the knowledge to clear my own drain without calling a plumber. Thank you!!

Hey man, you look like that billionaire Brian *something* that takes young blood transfusions.

1. Drill the hole roughly 1/8" larger than your anchor. 2. Use compressed air to blow out and Shop-Vac the dust at the same time. DO NOT USE WATER! 3. Use a long wire bore brush to score and rough out the hole. This roughing helps the epoxy to grab onto the sides of the hole. 4. Blow out and vaccum again. 5. Then, install your epoxy and all-thread anchor.

Dude what the fuck was Honda thinking? If you order the pads for the same year car, with the same engine, the fucking pads are different. What the fuck is the point of that? Fuck you, Honda. Just because it's different doesn't mean it's fucking better.

No just hire someone to do it concrete sucks everything about it

The blue can of oven cleaner means that it is the "fume free" version of Easy Off, that is, the version that does not contain sodium hydroxide aka lye. If it doesn't work, you might tyr the yellow can, which contains lye. Careful. Try some on a small spot first and use gloves. If it gets on your fingers, it feels slippery. That's because it's dissolving the outer layer of your skin.

Great video, though one question before I do this - I have a pedestal sink with very limited room behind it (can't even get a full, unobscured angle to see all the pipe), what do I do in lieu of a bucket, just place towels down? I'm not sure how much water to expect.

Hell yes I found this video helpful. Putting those temporary nailers up for the gate construction is a great idea. Thanks.

Easily one of the worst video's I've seen in a while. "just buy an new fill valve"

what about in wood?

Mask outside with such a small quantity is a bit much right?

You need a piece of metal between that wood and that concrete.

I don't trust any trade professional wearing sandals 😢!

Outv all the videos iv watched this is the most helpful and smartest way .thank you

What if your ground is concrete?

Why not a 6×6,holes aren't deep enough, and why use a shit hand saw

Where did you dispose of all the toxic materials, in your trashcan??

Mixing in a big wheelbarrow would maybe have been easier but looks good!

Not don’t pour on grass or dirt! Use gravel as a base then tamp

No mames!

Guess what your homeowners insurance won't cover damages caused by a faulty self installation. Electrical fire water damage you are on your own.

Imagine when he discovers a mixer

I’m looking at the video to see how we can get rid of our sunroom. The previous owner built it on the house but I can’t see my pretty backyard. So we are opening it up.

Uhhhhh....... ok Don't strain yourself

Not

HINT: Installing a "D" handle on top of the sliding gate lock would make it easier to move back and forth.

Tell you what way easier

Hey, shout out to you thank you 9 year old video but it helped took me 40 minutes mileage lights up. Thank you again. Took it to the dealership and they wanted to replace the cluster $500 intermittent, would light up when it wanted to. it’s really getting, to be a pain it was staying off longer now.